A Z28 302 INTAKE MANIFOLD, I RAN THIS INTAKE ON MY CAMERO MANY YEARS AGO , I HAD REMOVED AND CLEANED IT AND IT HAS BEEN WRAPPED  UP ON  THE SHELF SINCE 1983, THE THREAD HOLES ALL ARE VERY GOOD EXCEPT THE HEATER HOSE ON RIGHT FRONT IS NOT PERFECT BUT WORKED FINE WHILE I WAS RUNNING IT,  I HAD REPLACE THE FITTING BACK THEN AND COATED THE NEW ONE WITH SILICONE SEAL , I MOVED ALL THE STUDS AND FITTINGS I NEEDED TO AN AFTERMARKET INTAKE YEARS AGO,  TODAY I JUST RAN A TAP DOWN IN THE THREADS OF THE HOSE INLET  AND WHEN IT IS INTO THE THREADS IT HAS NO WOBBLE, A  NICE TIGHT FIT, THERE ARE A FEW VERY LIGHT WRENCH ? DINGS HERE AND THERE, THEY COULD BE LIGHTLY FILED AND RETEXTURED IF ONE WANTED THE INTAKE TO BE SHOW QUALITY ON A NICE CAR, THERE IS SOME PITTING ON THE REAR WATER JACKET FACE SEE PICTURE 10 AND 11 CAUSED BY ELECTROLISIS, THOSE AREAS SHOULD BE COATED WITH EPOXY TO STOP FURTHER ACTION,  OR MAKE SURE YOUR COOLANT IS KEPT AT PROPER CONDUCTIVITY, THERE IS A VERY SMALL DING OR PECK ON THE GASKET FACE OF INTAKE RUNNER IT CAN BE SEEN IN THE UPPER RIGHT  SIDE OF  11TH PICTURE , I ONLY MENTION ALL THESE SMALL DEFECTS SO NO ONE WILL BE DISAPOINTED IN THIS ITEM, MANY WOULD NOT NOTICE THEM, THAT SMALL SPOT WOULD POSE NO PROBLEM WITH A SMALL AMOUNT OF GASKET SEALANT,  COULD BE TIGGED IF ONE WISHED, I DO A FEW RESTORATIONS AND WOULD PROVIDE THAT SERVICE IF ONE WANTED,  I HAVE ANOTHER Z28 INTAKE IT HAS HAD A FEW REPAIRS YEARS AGO , AND I RAN IT AS IT IS ALSO, I MAY LIST IT , ALSO A FEW AFTER MARKET SMALL BLOCK INTAKES AND SOME MOTOR PARTS 350 FORGED CRANK, STROKER CRANK, + PISTONS SOME 55 + 56 AND 67 8 9 CAMERO CHEVY BODY PARTSANY QUESTIONS ABOUT ITEM PLEASE CALL  my cell#870-665-1915.